Heavy Duty Extension Lead 10m 63A 230V Blue IP67

Description

A heavy-duty 10 metre 63A extension lead with a 63A CEE three-pin plug and socket on 16mm cable. For large generators with a 63A outlet feeding a full kitchen trailer.

Features & Benefits

• 10 metres of 16mm heavy-duty cable, sized for 63A.
• 63A CEE three-pin plug and socket.
• IP67 watertight — sealed against puddles, hose-down and wet ground. The right choice for wash-down areas and waterlogged sites.
• Check the socket on your generator first. The plug on this lead must match it: 13A is the square three-pin domestic plug, 16A is the round blue industrial plug, 32A is the larger round blue plug and 63A is the largest.
• Read the full technical specification in the Specs tab.

Frequently asked questions

How much power can this 63A lead carry?

Up to 63A at 230V, which is about 14.5kW (63 × 230 = 14,490W). Add up the wattage of everything plugged in at the far end and keep the total below that figure. If it comes out higher, you need a lead and a generator outlet with a higher amp rating.

Will this lead fit my generator?

It fits generators with a 63A CEE outlet, the largest round blue industrial connector. Few portable generators have one. The GB12000VL AS auto-start generator can be built with a single 63A 230V socket. Most mobile catering setups run on 16A or 32A instead.

What does IP67 mean on an extension lead?

IP67 means the connectors are dust-tight and protected against temporary immersion in water, as long as the plug is fully mated or the cap is closed. That makes this lead the safer choice on wet ground, near wash-down areas and at all-weather events.

Should I unwind the lead fully before use?

Yes. Always uncoil the whole lead before you switch on. Cable left in a coil cannot shed heat, and under a heavy load it can overheat.